Mitsubishi Electric MR-E A Series Instruction Manual page 272

15. MR-E-
15.3.2 Torque control mode
(1) Power on
1) Switch off the servo-on (SON).
2) When power is switched on, the display shows "U (torque command voltage)", and in two second
later, shows data.
(2) Test operation
Using jog operation in the test operation mode, make sure that the servo motor operates. (Refer to
Section 6.8.2.)
www.DataSheet4U.com (3) Parameter setting
Set the parameters according to the structure and specifications of the machine. Refer to Chapter 5 for
the parameter definitions and to Sections 6.5 for the setting method.
Parameter No.
0
1
8
9
10
11
12
13
14
28
Turn the power off after setting parameters No. 0 and 1. Then switch power on again to make the set
parameter values valid.
(4) Servo-on
Switch the servo-on in the following procedure:
1) Switch on power supply.
2) Switch on the servo-on (SON).
When placed in the servo-on status, the servo amplifier is ready to operate and the servo motor is
locked.
(5) Start
Using speed selection 1 (SP1) and speed selection 2 (SP2), choose the servo motor speed. Turn on
forward rotation select (DI4) to run the motor in the forward rotation (CCW) direction or reverse
rotation select (DI3) to run it in the reverse rotation (CW) direction, generating torque. At first, set a
low speed and check the rotation direction, etc. If it does not run in the intended direction, check the
input signal.
On the status display, check the speed, load factor, etc. of the servo motor.
When machine operation check is over, check automatic operation with the host controller or the like.
AG SERVO AMPLIFIER COMPATIBLE WITH ANALOG INPUT
Name
Control mode, regenerative brake
option selection
Function selection 1
Internal speed limit 1
Internal speed limit 2
Internal speed limit 3
Acceleration time constant
Deceleration time constant
S-pattern acceleration/deceleration time
constant
Torque command time constant
Internal torque limit 1
Setting
0 4
Torque control mode
Regenerative brake option is not used.
0 2
Input filter 3.555ms (initial value)
Electromagnetic brake interlock (MBR) is not used.
1000 Set 1000r/min.
1500 Set 1500r/min.
2000 Set 2000r/min.
1000 Set 1000ms.
500 Set 500ms.
0 Not used
2000 Set 2000ms
50 Controlled to 50% output
15 - 27
Description