Electrical Connections - Electrolux KITWSRT Use And Installation Manual

USE AND INSTALLATION MANUAL

2.1.2. ELECTRICAL CONNECTIONS

Connect the general power plug of the ES control panel of skid 1 to a single-phase electrical power outlet.
Connect the skid 2 salt deposit from the EO board to the ES board of the skid 1 (see points 3-4 of the connection
diagram)
GENERAL INFORMATION
The machine must be connected to an earthed power outlet.
Before installing the machine, check the efficiency of the earthing. Check that the power line
and voltage are suitable for the power of the machine being installed and that the electrical
cable section is not less than 1.5 mm
Before removing the covers, panels, protection grilles and accessing the electrical parts,
disconnect the control panel from the power supply.
The electrical power supply of the machine is indicated on the data plate. Voltage variations
over 10% of the nominal value can damage the electrical parts of the machine, therefore, it
is advisable to always check the power voltage.
2
.
20