Table of Contents
Advertisement
USE AND INSTALLATION MANUAL
2.2.3. STARTING THE SALT STORAGE SKID
Before starting the softeners:
-Add untreated water until the extraction filter (A) is covered, about 10 litres;
-Remove the floats and fill with salt;
-Place the floats vertically at the top and position them horizontally on the salt.
CAUTION
USE GOOD QUALITY SALT WITH NO EARTH RESIDUE. IT IS ADVISABLE TO USE
SALT TABLETS TO REDUCE THE RISK OF HOLLOWS FORMING IN THE TANK.
2.2.4. PERIODIC REFILLING
Periodically check that the salt level reaches about halfway up the tank. If the indicator light comes on, check and
top up the salt in all three tanks.
C
A
B
1. Remove the floats
2. Refill to the edge of the tanks
3. Lift the float upwards to reset the alarm
800
4. Place the float horizontally on the salt
1-2
Figura a
1100
3
Figura b
4
Figura c
24
Advertisement
Table of Contents
