Hardware/Software Requirements - Siemens SIMATIC S7-1500 System Manual

Configuring

9.2 Hardware/software requirements

9.2 Hardware/software requirements
Hardware requirements
The following requirements must be met for commissioning the SIMATIC Drive Controller:
• Your plant has been installed and wired.
• Your PG/PC has been connected to the SIMATIC Drive Controller over the PROFINET or
PROFIBUS interface.
Software requirements
Table 9- 1
Configuration in the TIA Portal
Integrated SIMATIC S7-1500 CPU
SINAMICS Integrated
Additional information
You can find an overview of the most important documents and links for the TIA Portal on the
Internet (https://support.industry.siemens.com/cs/en/en/view/65601780).
You can find manuals, application examples and FAQs on Motion Control
(https://support.industry.siemens.com/cs/ww/en/view/109751049) on the following topic
page.
Note
Configuration without STEP 7/SINAMICS Startdrive
If you want to open projects that already contain a SIMATIC Drive Controller and a SINAMICS
drive, you need STEP 7 and SINAMICS Startdrive.
138
Required configuration software
Requirement
SIMATIC STEP 7 Professional, V16 or higher
For programming the safety program of the F-CPU
"STEP 7 Safety Advanced" from V16 onwards
SINAMICS Startdrive Basic or Startdrive Advanced,
V16 or higher
System Manual, 11/2023, A5E46600094-AD
SIMATIC Drive Controller