Siemens SICHARGE UC 150 UL Installation And Operation Manual page 51

Required tools and fasteners
To mount the SICHARGE UC dispenser, you need the following tools:
• Torque wrench
• Hexagonal socket
The mounting material is not included in the scope of delivery.
We recommend the following fixing material for mounting the SICHARGE UC dispenser to the mounting surface:
• 4 bolt anchors M12
• 4 washers M12
• 4 nuts M12
• Screw lock (for example, Loctite 243)
Mounting the SICHARGE UC dispenser
To position the SICHARGE UC dispenser on the mounting surface, follow these steps:
1. Position the SICHARGE UC dispenser on the mounting surface using the bottom bolt anchor.
2. Check whether the alignment of the SICHARGE UC dispenser above the bottom bolt anchor
of the mounting surface is correct.
3. Lower the SICHARGE UC dispenser onto the bottom bolt anchor.
4. Attach the washers to the bottom bolt anchors.
5. Screw the cap nuts onto the bottom bolt anchors.
6. Remove the lifting gear and the shackles from the top mounting rail.
7. Slide the SICHARGE UC dispenser onto the top bolt anchor up to the mounting surface.
8. Attach the washers to the top bolt anchors.
9. Attach a bolt lock to the top bolt anchors. We recommend Loctite 243.
10. Screw the cap nuts onto the top bolt anchors.
11. Unscrew the bottom cap nuts to a moderate degree.
12. Attach a bolt lock to the bottom bolt anchors. We recommend Loctite 243.
13. Tighten all nuts with the tightening torque of the bolt anchors per the manufacturer's instructions.
Installation and Operations Manual | SICHARGE UC 150 UL Plug-in Dispenser
51