Siemens SICHARGE UC 150 UL Installation And Operation Manual page 98

SICHARGE UC 150 UL Plug-in Dispenser | Installation and Operations Manual
Description
Q5-Primary Heater Trafo CB Opened
CB1-Secondary Control Trafo CB Opened
CB2-24V Digital Control PS Input CB Opened
CB3-24V Analog Control PS Input CB Opened
CB4-24V Output Contactor PS Input CB Opened
CB21-Sceondary Peripheral Trafo CB Opened
CB5-Bridge Rectifier Heatsink Fan CB Opened
CB6-IGBT Heatsink 1 Fan CB Opened
CB7-IGBT Heatsink 2 Fan CB Opened
CB8-Output Diode heatsink Fan CB Opened
High Cabinet Temperature Derating
High Cabinet Temperature Shutdown
Low Cabinet Temperature Derating
Low Cabinet Temperature Shutdown
CAN Communication Lost
Discharge Failed
Cable Check Failed
98
Error Error
Code Handling
55 Check feedback wire between PLC and Q5 for a broken wire or a
loose connection
Check Q5 for damage
56 Check feedback wire between PLC and CB1 for a broken wire or a
loose connection
Turn CB1 off and on
57 Check feedback wire between PLC and CB2 for a broken wire or a
loose connection
Turn CB2 off and on
58 Check feedback wire between PLC and CB3 for a broken wire or a
loose connection
Turn CB3 off and on
59 Check feedback wire between PLC and CB4 for a broken wire or a
loose connection
Turn CB4 off and on
60 Check feedback wire between PLC and CB21 for a broken wire or a
loose connection
Turn CB21 off and on
61 Check feedback wire between PLC and CB5 for a broken wire or a
loose connection
Turn CB5 off and on
62 Check feedback wire between PLC and CB6 for a broken wire or a
loose connection
Turn CB6 off and on
63 Check feedback wire between PLC and CB7 for a broken wire or a
loose connection
Turn CB7 off and on
64 Check feedback wire between PLC and CB8 for a broken wire or a
loose connection
Turn CB8 off and on
65 Check the air filter for dirt
66 Check the air filter for dirt
67 Ensure that the ambient temperature is not below -25 Celsius
Ensure that the heaters are operational
68 Ensure that the ambient temperature is not below -25 Celsius
Ensure that the heaters are operational
69 Termination of CAN communication can be caused by various
specific events
Repeat the charging process
Check whether the fault persists
Check whether the control of the power converter is
switched on and the LEDs are flashing
Check the CAN connections on the SinePower board and the AKKA
controller
71 Check F13 for a blown fuse
Check R13 for damage
Check K13 for damage
Ensure that K13 is opening and closing at the appropriate time
72 Check that the IGBTs are properly switching
Check the rectifiers for damage
Check for a balanced DC link voltages
OCPP Error
Category
OverCurrentFailure
OverCurrentFailure
OverCurrentFailure
OverCurrentFailure
OverCurrentFailure
OverCurrentFailure
OverCurrentFailure
OverCurrentFailure
OverCurrentFailure
OverCurrentFailure
HighTemperature
HighTemperature
OtherError
OtherError
InternalError
InternalError
InternalError