Fujitsu PRIMERGY RX200 S2 User Manual page 176

Chapter 7 Installing Internal Options
■ Notes on Installing Memory Modules
●
Identifying Memory Modules
When installing memory modules check that the number beginning with "CA" (e.g., CA05946-E101)
printed on the label is identical on the two DIMMs. Be sure to install a pair of modules with the same
number.
If the DIMMs have identification labels, be sure to install a pair of DIMMs with the same capacity and
the label placed on the same location.
The figure below shows the identification label locations.
Identification label A
1
Check the identification labels in a position where the circled corner is on the left as shown in the above
figure. Identification labels are applied in any of the following patterns.
Pattern
1
2
3
4
5
6
7
8
A: Label applied
-: Label not applied
176
Identification label B Identification label C
table: List of Identification Label Location Patterns
Identification label A Identification label B
-
A
-
-
A
A
-
A
Identification label C
- -
- -
A -
- A
A -
- A
A A
A A