Installing A 2.5-Inch Hdd/Ssd Module; Required Tools; Preliminary Steps; Removing The 2.5-Inch Dummy Module - Fujitsu Primergy BX920 S4 Upgrade And Maintenance Manual

6.2

Installing a 2.5-inch HDD/SSD module

Customer Replaceable Units (CRU)
Average task duration: 5 minutes
6.2.1

Required tools

Preliminary and concluding steps: tool-less
●
Main steps: tool-less
●
6.2.2

Preliminary steps

Perform the following procedures:
"Opening the rack door" on page 52
Ê
Ê When installing an SAS HDD/SSD drive make sure that one of the following
conditions is fulfilled
– SAS HDD/SSD backplanes are installed, see section
HDD/SSD backplanes" on page
– PCH HDD/SSD backplanes and onboard SAS enabling key are installed,
see section
"Onboard SAS enabling key" on page
6.2.3

Removing the 2.5-inch dummy module

I
Dummy modules protect free bays against environmental impact.
Remove the dummy module before installing an additional HDD/SSD
module.
BX920 S4
"Replacing HDD/SSD backplanes" on page 113
Upgrade and Maintenance Manual
Hard disk drives / solid state drives
113.
238.
"Replacing
and section
103