9.3.4
Concluding steps
Perform the following procedures to complete the task:
Ê Install the processor heat sink onto the processor as described in section
"Installing processor heat sinks" on page
Ê If memory modules have been removed, install the memory into their original
location as described in section
Ê Close the server blade as described in section
page
57.
Ê Reinstall and secure the server blade in the system unit as described in
section
"Installing the server blade in the system unit" on page
Ê If applicable, close the rack door as described in section
door" on page
Ê Enable boot watchdog functionality as described in section
watchdog functionality" on page
Ê If BitLocker functionality is used and has been disabled before starting the
maintenance task, re-enable BitLocker as described in section
BitLocker functionality" on page
BX920 S4
"Installing a memory module" on page
62.
Upgrade and Maintenance Manual
202.
"Closing the server blade" on
86.
93.
Processors
173.
58.
"Closing the rack
"Enabling boot
"Enabling
197