Fujitsu Primergy BX920 S4 Upgrade And Maintenance Manual page 250

System board components
Ê When iSCSI boot is used via onboard CNA, the Onboard CNA OpROM has
to be enabled in the system board BIOS. If applicable, proceed as described
in section "Enabling Option ROM scan" on page
Ê If applicable, activate TPM functionality in the system BIOS under Security >
TPM (Security Chip) Setting > Security Chip. For more information, refer to the
"D3142 BIOS Setup Utility for PRIMERGY BX920 S4" reference manual.
Ê Verify and update time settings as described in section
time settings" on page
Ê Inform the customer about changed WWN and MAC addresses. For further
information, refer to section
on page 94.
Ê After replacing the system board in a server blade running Linux OS, update
the MAC address of the onboard network controller in the related NIC
definition file as described in section
a Linux environment" on page
Ê Enable boot watchdog functionality as described in section
watchdog functionality" on page
Ê If BitLocker functionality is used and has been disabled before starting the
maintenance task, re-enable BitLocker as described in section
BitLocker functionality" on page
Ê If applicable, restore LAN teaming configurations as described in section
"After replacing the server blade" on page
Ê Please observe the notes on RAID rebuild in section
array rebuild" on page
250
88.
"Looking up changed MAC / WWN addresses"
91.
86.
93.
94.
Upgrade and Maintenance Manual
82.
"Verifying the system
"Updating the NIC configuration file in
97.
"Performing a RAID
"Enabling boot
"Enabling
BX920 S4