Replacing The Sas Raid Hdd Module; Concluding Steps - Fujitsu Primergy BX920 S4 Upgrade And Maintenance Manual

7.2.4.3

Replacing the SAS RAID HDD module

I
The following procedure is identical for both variants of SAS RAID HDD
modules.
Ê Remove the defective SAS RAID HDD module as described in section
"Removing the SAS RAID HDD module" on page
Ê Install the new SAS RAID HDD module as described in section
the SAS RAID HDD module" on page
7.2.4.4

Concluding steps

Perform the following procedures to complete the task:
Ê Close the server blade as described in section
page 57.
Ê Reinstall and secure the server blade in the system unit as described in
section "Installing the server blade in the system unit" on page
After installing or replacing an SAS RAID HDD module, update the firmware
Ê
as described in section
Ê In order to configure an SAS RAID HDD module that has been installed or
replaced, the module's Option ROM has to be enabled in the system board
BIOS. If applicable, proceed as described in section
scan" on page
Ê Enable boot watchdog functionality as described in section
watchdog functionality" on page
Ê If BitLocker functionality is used and has been disabled before starting the
maintenance task, re-enable BitLocker as described in section
BitLocker functionality" on page
Ê Please observe the notes on RAID rebuild in section
array rebuild" on page
BX920 S4
"Updating mezzanine card firmware" on page
82".
93.
94.
Upgrade and Maintenance Manual
Expansion cards and backup units
147.
144.
"Closing the server blade" on
86.
"Installing
58.
"Enabling Option ROM
"Enabling boot
"Enabling
"Performing a RAID
80".
151