Concluding Steps - Fujitsu Primergy BX920 S4 Upgrade And Maintenance Manual

Expansion cards and backup units
Figure 46: Installing the SAS RAID HDD module
Ê Push the SAS RAID HDD module under the three plastic catches of the
holder (see ovals) (1).
Ê Connect the riser card to the SAS connector on the system board (2).
7.2.2.4

Concluding steps

Perform the following procedures to complete the task:
Ê Close the server blade as described in section
page 57.
Ê Reinstall and secure the server blade in the system unit as described in
section "Installing the server blade in the system unit" on page
After installing or replacing an SAS RAID HDD module, update the firmware
Ê
as described in section
Ê In order to configure an SAS RAID HDD module that has been installed or
replaced, the module's Option ROM has to be enabled in the system board
BIOS. If applicable, proceed as described in section
scan" on page
Ê Enable boot watchdog functionality as described in section
watchdog functionality" on page
146
"Updating mezzanine card firmware" on page
82".
86.
Upgrade and Maintenance Manual
"Closing the server blade" on
58.
"Enabling Option ROM
"Enabling boot
80".
BX920 S4