Removing The Sas Raid Hdd Module; Concluding Steps - Fujitsu Primergy BX920 S4 Upgrade And Maintenance Manual

Expansion cards and backup units
Ê Remove the server blade from the system unit as described in section
"Removing the server blade from the system unit" on page
Ê Open the server blade as described in section
on page 56.
7.2.3.3

Removing the SAS RAID HDD module

I
The following procedure is identical for both variants of SAS RAID HDD
modules.
Figure 47: Removing the SAS RAID HDD module
Ê Remove the SAS RAID HDD module together with the riser card from the
system board.
7.2.3.4

Concluding steps

Perform the following procedures to complete the task:
Ê Close the server blade as described in section
page 57.
Ê Reinstall and secure the server blade in the system unit as described in
section "Installing the server blade in the system unit" on page
Ê Enable boot watchdog functionality as described in section
watchdog functionality" on page
148
86.
Upgrade and Maintenance Manual
55.
"Opening the server blade"
"Closing the server blade" on
58.
"Enabling boot
BX920 S4