NEC Univerge SV8100 Programming Manual page 25

Digitcom Canada Inc. Need Support? Call 1-866-667-8357 Visit us at: www.digitcom.ca
UNIVERGE SV8100
Password
47544
12345678
0000
9999
H
S 4
OW TO
ECTION
To exit the programming mode:
When you are done programming, you must be out of a program option to exit
(pressing the Answer key will exit the program option).
1.
2.
3.
Programming Manual
User
Level
Name
necii 1 (MF)
2 (IN)
tech
3 (SA)
ADMIN1
4 (SB)
ADMIN2
E P
XIT ROGRAMMING
Press Answer key to exit the program options, if needed.
Program Mode
Base Service OP1 OP2
Press Speaker. If changes were to the system programming, "Saving System
Data" is displayed.
The display shows "Complete Data Save" when completed and exits the
telephone to an idle mode.
To save a customer's database, a blank USB Drive is required. Insert the USB Drive into
the CD-CP00-US and, using Program 90-03, save the software to the USB Drive.
(Program 90-04 is used to reload the customer data if necessary.) Note that a USB Drive
can only hold one customer database. Each database to be saved requires a separate
drive.
Programs at this Level
Manufacturer (MF):
All programs
Installation (IN):
All programs in this section not listed below for SA and
SB
System Administrator – Level 1 (SA):
10-01, 10-02, 10-12, 10-13, 10-14, 10-15, 10-16, 10-17,
10-18, 10-22, 12-02, 12-03, 12-04, 15-01, 15-07, 15-09,
15-10, 15-11, 20-16, 21-07, 21-14, 22-04, 22-11, 25-08,
30-03, 32-02, 40-02, 41-02, 41-03, 41-04, 41-05, 41-06,
41-07, 41-08, 41-09, 41-10, 41-11, 41-12, 41-13, 41-14,
41-15, 41-16, 41-17, 41-18, 90-03, 90-04, 90-06, 90-07,
90-18, 90-19
System Administrator – Level 2 (SB):
13-04, 13-05, 13-06
M
ODE
Issue 1.0
1 - 3