Service Tone Timers - NEC Univerge SV8100 Programming Manual

Digitcom Canada Inc. Need Support? Call 1-866-667-8357 Visit us at: www.digitcom.ca
UNIVERGE SV8100
Level:
IN
Description
Use Program 20-18 : Service Tone Timers to set the values for the system service
tone timers. Refer to the following chart for a description of each option, its range and
default setting.
Input Data
Item
No.
01
02
03
04
05
06
07
08
09
Programming Manual
Program 20 : System Option Setup
Input
Item
0~64800
Extension Dial Tone
Time
seconds
0~64800
Busy Tone Timer
seconds
0~64800
Congestion Tone
seconds
0~64800
Call Waiting Tone
Timer
seconds
0~64800
Multiline Confirmation
Tone
seconds
0~64800
Interval of Call
Waiting Tone
seconds
0~64800
Intrusion Tone Repeat
Time
seconds
0~64800
Conference Tone
Interval
seconds
Warning Beep Tone 0~64800
Signaling Interval
seconds

20-18 : Service Tone Timers

Default
Data
30 After getting Intercom dial tone,
a telephone user has this time
to dial the first digit of the
Intercom call.
15
10 A Busy Tone when system
resources run short. (such as
DTMF receiver resources).
10 This option sets the time
between Call Waiting tones.
This timer also sets the time
between Off-Hook Signaling
alerts.
10
10
0
After a call is interrupted (such
as Barge-In, Voice Mail
Conversation Recording, or
Voice Over), the system
repeats the Intrusion Tone after
this time. Normally, you should
enter 0 to disable this time.
0
60
Issue 1.0
Related
Description
Program
14-01-18
2 - 237