Service Tone Timers - NEC UNIVERGE SV8100 Programming Manual

Issue 11.0
Level:
IN
Description
Use Program 20-18 : Service Tone Timers to set the values for the system service
tone timers. Refer to the following chart for a description of each option, its range and
default setting.
Input Data
Item
No.
01
02
03
04
05
06
07
08
09
2 - 272
Program 20 : System Option Setup
Item
Extension Dial Tone 0~64800
Time
seconds
0~64800
Busy Tone Timer
seconds
Congestion Tone 0~64800
seconds
Call Waiting Tone 0~64800
Timer
seconds
Multiline Confirmation 0~64800
Tone
seconds
Interval of Call 3~64800
Waiting Tone
seconds
Intrusion Tone Repeat 0~64800
Time
seconds
Conference Tone 0~64800
Interval
seconds
Warning Beep Tone 0~64800
Signaling Interval
seconds

20-18 : Service Tone Timers

Input
Default
Data
30 After getting Intercom dial tone,
a telephone user has this time
to dial the first digit of the
Intercom call.
15
10 A Busy Tone when system
resources run short. (such as
DTMF receiver resources).
10 Sets the time between Call
Waiting tones. This timer also
sets the time between
Off-Hook Signaling alerts.
10
10
0 After a call is interrupted (such
as Barge-In, Voice Mail
Conversation Recording, or
Voice Over), the system
repeats the Intrusion Tone after
this time. Normally, you should
enter 0 to disable this time.
0
60
Program 20 : System Option Setup
UNIVERGE SV8100
Related
Description
Program
14-01-18