NEC UNIVERGE SV8100 Programming Manual page 88

Issue 11.0
Input Data (Continued)
Feature Cross Reference
None
2 - 46
05 Domain Assignment
If the information from
Telco was a domain
name
(siptrunk@sip.com)
then set to domain. If
the information for
Telco was a IP address
then set to IP Address.
06 IP Trunk Port
Binding
Trunk port binding is
only used for SIP trunks
to the provider in Non-
Registration Mode only.
When this is disabled,
an inbound call comes
in and follows your DID
routing but it comes in
on the first available
trunk. When enabled,
the inbound call comes
in and follows your
normal DID routing but
maps to that specified
trunk. If that trunk is
busy, it sends back a
busy unless you build a
hunt group. To build
the hunt group, it
references command
14-12-02 (pilot register
ID). This points you to
command 10-36-02. All
numbers with the same
pilot are in the same
hunt group.
Conditions
None
0 = IP Address
1 = Domain Name
0 = Disable
1 = Enable
Program 10 : System Configuration Setup
UNIVERGE SV8100
0
0