Single Line Telephone Basic Data Setup - NEC UNIVERGE SV8100 Programming Manual

UNIVERGE SV8100
Level:
IN
Description
Use Program 15-03 : Single Line Telephone Basic Data Setup to set up various
single line telephone options.
Input Data
Item
No
01
03
04
05
SV8100 Programming Manual
Program 15 : Extension, Basic Setup

15-03 : Single Line Telephone Basic Data Setup

Extension Number
Item
SLT Signaling Type
Select the type of dialing the connected
telephone uses.
For the UNIVERGE SV8100 Wireless
telephones to function correctly, this must be set
to 0. If this option is set for DTMF, after an
outside call is placed, the system cannot dial any
additional digit.
This program change is automatically performed
when the UNIVERGE SV8100 Wireless
telephone is registered. When upgrading
software from prior versions, the previous default
of 1 is saved from the prior database so this
option must be changed manually.
Terminal Type
Enter 1 for this option to allow a single line port
to receive DTMF tones after the initial call setup.
Enter 0 to have the port ignore DTMF tones after
the initial call setup. For Voice Mail, always enter
1 (e.g., receive DTMF tones).
Flashing
Enable/Disable Flash for single line (500/2500
type) telephones.
Trunk Polarity Reverse
Not Used in U.S. – Do Not Change Default Entry
as DTMF issues may arise with voice mail.
Maximum eight digits
Input Data Default
0 = DP 1
1 = DTMF
0 = Normal 0
1 = Special
0 = No
1
1 = Yes
0 = Off 0
1 = On
Issue 11.0
Related
Program
15-03-03
45-01-01
15-03-01
45-01-01
2 - 181