NEC UNIVERGE SV8100 Programming Manual page 597

UNIVERGE SV8100
Input Data (Continued)
Item
No.
07
08
09
10
SV8100 Programming Manual
Item
Recording Conversation Beep
(Rec Conv Beep)
Enable/Disable the Conversation Record beep. If
enabled, all parties on a call hear the voice prompt
"Recording", followed by a single beep when the
extension user initiates Conversation Record. If
disabled, the voice prompt and beep do not occur.
When you disable the Conversation Record beep,
the following voice prompts do not occur while
SV8100 InMail records the conversation:
Recording
(followed by a beep)
That mailbox is full
(if the mailbox message storage capacity is reached)
You have reached the recording limit
(if the recorded message is too long)
The UNIVERGE SV8100 telephone system software
provides an additional Conversation Record beep.
This beep repeats according to the setting of
Program 45-01-06: Voice Mail Integration
Options: Record Alert Tone Interval Time
(0~64800 seconds). To disable the UNIVERGE
SV8100 telephone system Conversation Record
beep, enter 0 for this option.
Message Waiting Lamp
(Update MW Lamp)
Enable/Disable Message Waiting lamps at the
extension associated with the Subscriber mailbox.
For Subscriber Mailboxes, enable this option. For
Guest Mailboxes, disable this option.
Auto Attendant Direct to Voice Mail
(Auto-ATT DND)
Enable/Disable Auto Attendant Do Not Disturb.
When a subscriber enables Auto Attendant Do Not
Disturb, an Automated Attendant caller routes
directly to the mailbox, hears the greeting, and is
asked to leave a message. A subscriber also can
enable Auto Attendant Do Not Disturb while
recording their mailbox greeting.
Forced Unscreened Transfer
(Forced UTRF)
Enable/Disable Automated Attendant Forced
Unscreened Transfer for the Subscriber Mailbox. If
enabled, each Screened Transfer (TRF) to the
extension is converted to an Unscreened Transfer
(UTRF). If disabled, Screened Transfers from the
Automated Attendant occur normally.
Input Data
0 = No (Disable)
1 = Yes (Enable)
0 = No (Disable)
1 = Yes (Enable)
0 = No (Disable)
1 = Yes (Enable)
0 = No (Disable)
1 = Yes (Enable)
Issue 11.0
Default
1
1
0
0
2 - 555