Fip-1. 73 Paper Jam 077-901............................................................................................................. 1 - Dell 2135cn Service Manual

FIP-1. 73 Paper Jam 077-901
Step
Possible causative parts:
CLUTCH ASSY DRV (PL3.1.1)
ACTUATOR REGI ROLL (PL3.2.8)
ROLL ASSY REGI (PL3.2.9)
ROLL REGI METAL (PL3.2.10)
ACTUATOR REGI IN (PL3.2.11)
SENSOR PHOTO (PL3.2.13)
TRANSFER ASSY (PL6.1.7)
DRIVE ASSY MAIN (PL7.1.2)
HARN ASSY L SIDE (PL10.4.18)
PWBA MCU (PL10.7.7)
HARN ASSY MAIN MOT (PL10.8.7)
HARN ASSY KSNR REGCL (PL10.8.9)
Checking the paper size
1
Does the using paper size meet the specification?
2 Does the error still occur when printing?
Checking the paper condition
3
Is the paper wrinkled or damaged?
4 Does the error still occur when printing?
Checking after reloading a new paper
5 Reload a new paper.
Does the error still occur when printing?
Checking the COVER ASSY FRONT for latching
Open and close the COVER ASSY FRONT, and then latch
6
correctly.
Does the error still occur when printing?
Checking around the Regi Sensor
7 Are there any remaining paper and/or foreign substance
around the Regi Sensor?
8 Does the error still occur when printing?
Checking the TRANSFER ASSY
9 Are there any remaining paper and/or damage on the belt of
the TRANSFER ASSY?
Checking the ROLL ASSY REGI and ROLL REGI METAL
for shape and operation
Remove the PHD UNIT once to check the followings.
Are ROLL ASSY REGI and ROLL REGI METAL seated
10
correctly?
Also, are they not contaminated and/or damaged, and
rotated smoothly?
Check these items by turning with your finger.
Version 2 2008.03.31
Check
1 - 316
Chapter 1 Troubleshooting
Remedy
Yes
Use the paper that
meets the
Go to step 3.
specifications,
then go to step 2.
Go to step 3. End of work.
Replace the paper
with a new and dry
Go to step 5.
one, then go to
step 4.
Go to step 6. End of work.
Go to step 6. End of work.
Go to step 7. End of work.
Remove the paper
and/or substance, Go to step 9.
then go to step 8.
Go to step 9. End of work.
Remove the
remaining paper. If
the belt is
damaged, replace
Go to step 10.
the TRANSFER
ASSY. (Refer to
Removal 48/
Replacement 12.)
Clean or replace
Go to step 11. the defective
ROLL(s).
No