Chapter 3 Removal and Replacement Procedures (RRPs)
Removal 33 KIT DRIVE ASSY MAIN (PL7.1.98)
1) Remove the Tray 1. (Removal 1)
2) Open the COVER ASSY FRONT (PL10.2.1).
Note: Cover the drum of the PHD unit to avoid exposure to light.
3) Remove the PHD Unit. (Removal 3)
Note: The FUSER part is very hot. Take added care not to get burned when performing the
service operation.
4) Remove the FUSER ASSY. (Removal 9)
5) Remove the COVER ASSY SIDE R. (Removal 10)
6) Remove the COVER ASSY SIDE L. (Removal 14)
7) Remove the COVER POLE OUT. (Removal 15)
8) Remove the COVER REAR. (Removal 17)
9) Remove the COVER TOP. (Removal 18)
10) Remove the CHASSIS ASSY LVPS. (Removal 28)
11) Remove the KIT DRIVE ASSY PH. (Removal 32)
12) Rotate the STOPPER PIVOT
(PL6.1.3), mate the tabs of the STOPPER
PIVOT with the notches of the DRIVE
ASSY MAIN (PL7.1.2).
13) Remove the STOPPER PIVOT from
the printer.
3 - 64
Version 1
2008.02.01