Dell 2135cn Service Manual page 433

Step
Checking the paper condition
9
Is the paper dry and recommended paper?
10 Is the image printed correctly?
Checking the COVER ASSY FRONT for latching
11 Open and close the COVER ASSY FRONT.
Is the image printed correctly?
12 Is the image printed correctly?
Checking after reseating the PHD UNIT
13 Reseat the PHD UNIT.
Is the image printed correctly?
Checking after reseating the TRANSFER ASSY
14 Reseat the TRANSFER ASSY.
Is the image printed correctly?
Checking the paper feeding tray
15
Is the skewed paper fed from the SSF?
Checking the side guides setting of SSF
16 Reset the side guides.
Is the image printed correctly?
Checking the paper path
17
Are there any foreign substances on the paper path?
18 Is the image printed correctly?
Checking the ROLL ASSY REGI and ROLL ASSY METAL
for rotation
Checked by [Digital Output]-[DO-00 and 29] of the [IOT
19 Diag] on the [Printer] of the diagnosis.
Does the Roll Assy Regi and Roll Regi Metal rotate?
During this check, cheat the interlock switch (HARN ASSY
INTERLOCK).
Checking after reseating the Paper Cassette
20 Reseat the Paper Cassette.
Is the image printed correctly?
Checking after reseating the paper
21 Reseat the paper in the Paper Cassette.
Is the image printed correctly?
Checking the side guides of the Paper Cassette
22 Reset the side guides.
Is the image printed correctly?
Checking the paper path
23
Are there any foreign substances on the paper path?
24 Is the image printed correctly?
Checking after reseating the SEPARATOR ROLLER
ASSEMBLY
25
Reseat the SEPARATOR ROLLER ASSEMBLY.
Is the image printed correctly?
Version 1 2008.02.01
Check
1 - 405
Chapter 1 Troubleshooting
Remedy
Yes
Replace the paper
with a new dry and
Go to step 11. recommended
one, then go to
step 10.
End of work. Go to step 11.
Replace the
End of work. defective parts,
then go to step 12.
End of work. Go to step 13.
End of work. Go to step 14.
End of work. Go to step 15.
Go to step 16. Go to step 20.
End of work. Go to step 17.
Remove the
foreign
Go to step 19.
substances, then
go to step 18.
End of work. Go to step 19.
Replace the ROLL
ASSY REGI and/
End of work.
or ROLL REGI
METAL.
End of work. Go to step 21.
End of work. Go to step 22.
End of work. Go to step 23.
Remove the
foreign
Go to step 25.
substances, then
go to step 24.
End of work. Go to step 25.
End of work. Go to step 26.
No