Chapter 3 Removal and Replacement Procedures (RRPs)
21) Disengage the connector (P/J1002) on
the PWBA CONT AIO, release the
clamp
harness of the IIT ASSY SUB from the
clamp, pull it out to outside from the hole
of the frame.
22) Remove the two screws (silver, 6mm)
that fix the IIT ASSY SUB to the printer.
23) Shift the IIT ASSY SUB to left side to
release the holes of the IIT ASSY SUB
from the four studs, lift the IIT ASSY SUB
up. Remove the IIT ASSY SUB together
with the ADF ASSY.
3 - 131
Version 2
2008.03.31