Brother DCP-7080 Service Manual page 187

(5) Remove the taptite cup S M3x8 SR screw to remove the ADF FG harness from the drive
frame ASSY.
(6) Remove the three taptite cup B M3x10 screws to remove the drive frame ASSY from the
lower document chute ASSY. Disconnect the ADF motor harness from the ADF motor.
(7) Release the hook to remove the gear 43 from the drive frame ASSY.
(8) Remove the screw pan (S/P washer) M3x6 screw. Turn the ADF motor in the direction of
the arrow, and release it from the claw to remove it from the drive frame ASSY.
Lower document
chute ASSY
ADF motor
harness
Claw
ADF motor
Harness routing: Refer to
Assembling Note:
• When attaching the drive frame ASSY, make sure that the lower chute support plate is
above the drive frame ASSY.
• Tighten the lower chute support plate and ADF FG harness together with a taptite cup
S M3x8 SR screw.
• Make sure that the terminal of ADF FG harness is located between the rib of the lower
document chute ASSY and the left side of the lower chute support plate as shown in
the figure below.
Lower document chute ASSY
Lower chute support plate
ADF FG harness
Drive frame ASSY
ADF motor
Screw pan (S/P washer) M3x6
Fig. 3-48
"8. ADF unit".
Fig. 3-49
3-54
Taptite cup S M3x8 SR
Lower chute support plate
Drive frame ASSY
Hook
Gear 43
Terminal of ADF FG harness
is within this area.
Rib
Terminal of ADF FG harness
Taptite cup B
M3x10
Confidential