Brother DCP-7080 Service Manual page 198

(4) Slide the CIS carriage slowly to the location shown in the figure below.
(5) Open the first side CIS unit at 90 degrees to the CIS carriage, and slide it in the direction
of the arrow to remove it by releasing the two bosses. Disconnect the first side CIS flat
cable from the first side CIS unit.
First side CIS unit
Boss
CIS carriage
Assembling Note:
• Acquire the white level data, and set the CIS scanning area.
(Refer to "Acquire white level data and set CIS scan area (function code: 55)" in
Chapter 5.)
First side CIS flat cable
Fig. 3-60
3-65
First side CIS unit
CIS carriage
Boss
Confidential