Brother DCP-7080 Service Manual page 60

Error Messages
Upper line
Self-Diagnostic Turn the power off,
then on again. Leave
the machine for 15 min.
Will Automatically
Restart within 15
minutes.
Size Error 2-sided Press Stop[x]. Specify
the correct paper and
load the same size
paper as Printer driver
setting.
Specify the correct
paper and press
[Retry].
Size mismatch Fax received. Set
correct paper size in
menu.
Reload correct paper.
Reload correct paper
in Tray, then press
[Retry].
Supplies Drum End Soon
Replace Drum
Replace Toner
Toner Low
Toner Ended Open the Front Cover,
replace Toner Cartridge.
Touchscreen Remove any material
Initialisation which is on the
Failed touchscreen.
Lower line
An error occurred in the fuser unit
when the power switch was turned
ON or sleep mode was released.
Rechecking the error after the
power switch was turned OFF and
then ON again because an error
was detected in the fuser unit.
(This message is displayed for
approximately 15 minutes when
the machine is restarted after error
code 6901 has occurred.)
The registration rear sensor
detected that the paper fed was
smaller or larger than the specified
size in duplex printing mode.
A tray set to duplex printing-
incompatible size was specified in
duplex printing.
The paper size setting for the
machine is other than A4, Letter,
Legal or Folio when receiving fax.
Detected that the size of the paper
set to paper tray was over 10 mm
shorter than letter size when
receiving fax or printing a list/
report.
When printing from the paper tray,
the size of paper set in the paper
tray does not match the size
specified by the driver.
The number of rotations of the
drum unit is reaching the upper
limit.
The number of rotations of the
drum unit has reached the upper
limit. (Printing does not stop.)
Dot count or develop roller counter of
the toner has reached the upper limit
in the toner continuous printing
mode.
Dot count or develop roller counter
of the toner is reaching the upper
limit.
The toner cartridge has reached the
upper limit in the toner continuous
printing mode.
An error occurred while initializing
the touch panel.
2-25
Description
Error Refer
codes to:
6901 2-42
6902 2-42
8A01 2-47
9701 2-50
8E01 2-48
8E02 2-48
9002 2-49
4000 2-38
4200 2-38
4D01 2-39
4B01 2-38
4E01 2-39
D800 2-56
Confidential