Setting By Spec (Function Code: 74); (Sub Firmware, Demo Firmware, Panel Firmware, And Main Firmware); Checking Firmware Version; Installing Firmware - Brother DCP-7080 Service Manual

1.1 Setting by Spec (Function code: 74)

Configure the setting by spec as described in
Chapter 5.
1.2 Installing Firmware (Sub firmware, demo firmware,
panel firmware, and main firmware)

1.2.1 Checking firmware version

Check whether the firmware installed on the machine is the latest version. If it is the latest
version, there is no need to install the firmware. If it is not, be sure to install the firmware to
the machine as described in
<How to check firmware version>
For models without touch panel
(1) Press the [Menu], and then the [Start]
key while the machine is in the ready
state. Then, press the [▲] key four
times to enter the maintenance mode.
(2) Press the [▲] or [▼] key to display
"MAINTENANCE 25" on the LCD, and
press the [OK] key. For keypad
models, press the [2] and [5] keys in
this order. The main firmware version
information is displayed on the LCD.
(3) Press the [Start] key to display the
version information of the sub
firmware and demo firmware on the
LCD, and then check the version
information.
Note:
• You can check the sub firmware, demo firmware, panel firmware, and main firmware
version by implementing "Print maintenance information (function code: 77)"
(refer to "1.3.24 Print maintenance information (function code: 77)" in Chapter
"1.3.23 Setting by spec (function code: 74)" in
"1.2.2 Installing firmware".
For models with touch panel
(1) Press and hold the [Home] key for
(2) Press and hold the blank field at the
(3) Press the [*], [2], [8], [6], and [4] keys
(4) Press the [2] and [5] keys in this order.
(5) Press the [Mono Start] key to display
4-2
approximately five seconds while the
machine is in the ready state.
bottom of the LCD for approximately
two seconds.
on the LCD in this order to enter the
maintenance mode.
The main firmware version information
is displayed on the LCD.
the version information of the sub
firmware, demo firmware, and panel
firmware on the LCD, and then check
the version information.
5).
Confidential