Setting By Spec (Function Code: 74) - Brother DCP-7080 Service Manual

1.3.23 Setting by spec (function code: 74)

<Function>
This function is used to customize the machine according to language, function settings, and
worker switch settings.
<Operating Procedure>
For models without keypad
(1) Press the [▲] or [▼] key in the initial
state of maintenance mode to display
"MAINTENANCE 74" on the LCD, and
press the [OK] key. The country code
currently set is displayed on the LCD.
(The first digit is flashing.)
(2) Press the [▲] key to enter "1", or the [▼]
key to enter "0". Then press the [OK]
key. The second digit starts to flash.
(3) Press the [▲] key to enter "1", or the [▼]
key to enter "0" similarly. Then press the
[OK] key. The second digit is completed
and the third and fourth digit starts to
flash.
(4) The third digit and fourth digit changes
at once when the [▲] or [▼] key is
pressed. Press the [Start] key when the
desired value is shown on the screen.
The new setting is saved, and
"PARAMETER INIT" is displayed on the
LCD. The machine then returns to the
initial state of maintenance mode.
Note:
• If there is no entry for one minute or longer, the machine returns to the initial state of
maintenance mode automatically, regardless of the display status.
For models with keypad
(1) Press the [7], and then the [4] key in the
initial state of maintenance mode. The
country code currently set is displayed
on the LCD.
(2) Enter the country code (four digits) you
want to set.
(3) Pressing the [Start] or [Mono Start] key
saves the new setting and
"PARAMETER INIT" is displayed on the
LCD. The machine then returns to the
initial state of maintenance mode.
5-39
Confidential