Brother DCP-7080 Service Manual page 254

<Operating Procedure>
For models without keypad
(1) Press the [▲] or [▼] key in the initial
state of maintenance mode to display
"MAINTENANCE 10" on the LCD, and
press the [OK] key. "WSW00" is
displayed on the LCD.
(2) Press the [▲] or [▼] key to display the
worker switch number for which you
want to change the setting on the LCD.
(3) Press the [OK] key. The following
display appears on the LCD.
Selector No. 1 Selector No. 8
WSWXX = 0 0 0 0 0 0 0 0
(4) Pressing the [▲] key enters "1", and
pressing the [▼] key enters "0". Press
either to enter desired number to
Selector No.1. The next digit starts
flashing.
(5) Keep entering numbers to Selector No.8
using the [▲] or [▼] key as described in
the procedure (4).
(6) Press the [OK] key. The new selector
setting value is stored in the EEPROM,
and the LCD returns to the ready state
for worker switch number entry
("WSW00").
(7) When all switch setting is completed,
press the [Stop] key to return the
machine to the initial state of
maintenance mode.
Note:
• To cancel operation and return to the initial state of maintenance mode, press the [X] or
[Stop] key.
• If there is no entry for one minute or longer after entering the first digit on 2-digits worker
switch number selection, the machine returns to the initial state of maintenance mode
automatically.
For models with keypad
(1) Press the [1], and then the [0] key in the
initial state of maintenance mode.
"WSW00" is displayed on the LCD.
(2) Enter the worker switch number that you
want to change the setting. The
following display appears on the LCD.
Selector No. 1 Selector No. 8
WSWXX = 0 0 0 0 0 0 0 0
(3) Press the [
cursor to the desired selector, and
change the setting by pressing the [1] or
[0] key.
(4) When changing the setting is
completed, press the [SET] or [OK] key.
The new selector setting value is stored
in the EEPROM, and the LCD returns to
the ready state for worker switch
number entry ("WSW00").
(5) When all switch setting is completed,
press the [X] or [Stop] key to return the
machine to the initial state of
maintenance mode.
5-10
] or [ ] key to move the
Confidential