To Install The Rptu Pcb - Toshiba Strata DK40 Installation & Maintenance Manual

RPTU ISDN Primary Rate Interface Unit
Program *63-1: Assigns a "Sub-Address Timeout" facility between dialled number and
"Sub-Address" information being sent to line
Program *63-2: Assigns a system "Inter Digit Pause Timeout" to start after a valid trunk
access code has been dialled
Programs 71~75: Assigns the stations that are to be members of the system groups nominated
(as per the settings in Program *09).
Program 76: Assigns Alpha Tagging to system groups nominated (as per Program *09).
Program 78: Assigns special ringing of lines; includes Night Ring Over Page, DISA, Remote
Maintenance via the Internal Maintenance Modem (IMDU), and integrated Auto Attendant.
Programs 81~89: (DEL Mode only)
Assigns lines to ring selected stations
Assigns Delayed Ringing to any line.
Program 93: Assigns names to lines

To Install the RPTU PCB

4. Turn the DK40 system power OFF.
5. Insert the RPTU (component side facing right) into the appropriate slot
Assignments" on Page
connectors.
6. After installing the RPTU, gently pull the PCB outward. If the connectors are properly
seated, a slight resistance is felt.
Note
Strata DK40 I&M Manual Spring 1999
Refer to the Strata DK40 Programming Manual or DK Library CD-Rom for more details.
3-29) and apply firm, even pressure to ensure proper seating of
For cabling information and requirements, refer to
DK40 Universal Slot PCBs
(see "Slot
"Cabling" on Page 3-34.
3-31