General Voice Mail (Standard Telephone Port) Programming; Voice Mail Program Checklist - Toshiba Strata DK40 Installation & Maintenance Manual

Voice Mail Options
General Voice Mail (Standard Telephone Port)
Programming
Voice mail (VM) KSTU3, RSTU or PSTU port programming is accomplished using
Programs 31 and 10-2. (Refer to Strata DK40 Programming Manual for more details.) VM
programming features are as follows:
VM Groups
This feature groups VM KSTU3, RSTU or PSTU ports together so that message waiting set/
cancel signals appear to originate from the lowest port in the VM group. All VM ports
connected to a particular VM machine should be set in the same VM group (Program 31,
LEDs 05~08).
Message Waiting (MW) Set/Cancel
If the VM machine has the ability to dial a code and the appropriate station numbers to set or
cancel the message waiting LEDs on digital and electronic telephones, you can use Program
10-2, LED 04 to instruct the VM machine to set or cancel a MW LED. See the Strata DK40
Programming Manual for more information.
Note
No Conference VM
Prevents undesired three-party connections during VM call transfers. All VM ports should be
set for No Conference (Program 31, LED 09).
Privacy Override Deny
Prevents stations from overriding (breaking in) in-progress VM calls (Program 31, LED 18).
End-to-End Signalling
Enables VM port DTMF operation. All VM ports should be set for end-to-end signalling
(Program 31, LED 17).
Note
Receive Auto Call Forward ID Codes
Provides auto digits from call forwarded stations to direct callers to station mailboxes. All
VM ports should be set to receive auto ID code (Program 31, LED 16).

Voice Mail Program Checklist

Prior to Programming
See Toshiba Stratagy or Stratagy DK documentation for other parameter settings.
Strata DK40 I&M Manual Spring 1999
Refer to the Strata DK40 Programming Manual or DK Library CD-Rom for more details.
Only dial codes &96 and &97 are set in the VM device configuration; the VM
device dials the station number automatically to set/cancel the MW LED.
The K5RCU must be installed on the DK40 to enable End-to-End Signalling.
Peripheral Installation
6-47