Siemens SINAMICS G150 Operating Instructions Manual page 221

NOTICE
You should only check the "Do you want to enter equivalent circuit diagram data?" box if
the data sheet with equivalent circuit diagram data is available. If any data is missing, an
error message will be output when the system attempts to load the drive project to the
target system.
⇒ Click Continue >
Configuring the motor – Entering optional data
Figure 5-19
⇒ If required, enter the optional motor data.
⇒ Click Continue >
Converter cabinet units
Operating Instructions, 03/2012, A5E03263466A
Entering optional motor data
5.3 Procedure for commissioning via STARTER
Commissioning
219