Siemens SINAMICS G150 Operating Instructions Manual page 659

Motor data set, 267
Motor identification, 420
Motorized potentiometer, 285
Mounting
Canopies and hoods, 56
Canopy to increase the degree of protection to
IP21, 57
Hood to increase the degree of protection to
IP23/IP43/IP54, 58
N
NAMUR
Outlet for external auxiliaries (option B03), 198
Separate 24 V DC power supply (option B02), 198
NAMUR terminal block (option B00), 196
Non-grounded system, 87
O
OFF Key, 303
ON Key, 303
Online operation with STARTER, 344
open actual speed value, 403
Operating hours counters, 458
Operation in the IT system (option L21), 131
Operation on a non-grounded system, 87
Operation screen, 290
Operator input inhibit / parameters inhibit key, 306
Operator panel, 239
Overview, 288
Option K95, 185
Option M90 (crane transport aids), 50
Option short codes, 35
Original roof screws, 51
Outgoing section for external auxiliary equipment for
NAMUR (option B03), 198
Output terminals, 413
Overload capability, 586
Overload responses, 497
P
Parallel operation of communication interfaces, 362
Parameter request and parameter response, 323
Parameter reset, 254
Parameter reset via STARTER, 254
Resetting Parameters via AOP30, 254
Parameterization errors, 310
Permanent-magnet synchronous motors, 409
Power block
Converter cabinet units
Operating Instructions, 03/2012, A5E03263466A
Crane lifting lugs, 535
Frame size FX, replacement, 547
Frame size GX, replacement, 549
Frame size HX, replacement, 551
Frame size JX, replacement, 555
Power connections, 78
Connecting the motor and power cables, 81
Power supply, internal, 86
Preparation
Mechanical installation, 44
PROFIBUS, 336
Address switches, 103, 342
Bus terminating resistor, 102, 338
Connectors, 102, 337
Setting the address, 103, 341
Setting the PROFIBUS Address, 341
PROFIBUS connection, 101, 336
PROFIdrive, 310
Acyclic communication, 321
Application classes, 312
Controller, 310
Cyclic communication, 317
Drive Unit, 310
Supervisor, Drive Unit, 310
PROFINET
Connection channels, 353
Data transfer, 352
PROFINET interface, 193
PROFINET IO, 348
Addresses, 350
Device name (NameOfStation), 351
IP address, 351
IP address assignment, 351
MAC address, 350
RT and IRT, 349
PROFINET IO with IRT, 350
PROFINET IO with RT, 349
Protecting power components, 496
Protective functions, 496
PT100, 503
PT100 evaluation unit (option L86), 151
PTC, 503
Pulse frequency wobbling, 456
Q
Quality, 23
R
Ramp-function generator, 372
Index
657