Siemens SINAMICS G150 Operating Instructions Manual page 464

Converter cabinet units 75 kw to 1500 kw

Hide thumbs Also See for SINAMICS G150:

Table of Contents

Functions, Monitoring, and Protective Functions

9.2 Drive Functions

Changing over the units

The units can be changed over via the AOP30 and via STARTER.

● Unit changeover via AOP30 is always carried out immediately. Once the corresponding

● If STARTER is used, unit changeover can only take place in offline mode in the

Each parameter that can be switched is assigned to a unit group which can be switched

within certain limits depending on the group.

This assignment and the units groups for each parameter appear in the parameter list in the

SINAMICS List Manual.

The unit groups can be individually switched using 4 parameters (p0100, p0349, p0505 and

parameters have been changed, the values affected are displayed in the new selected

configuration screen of the corresponding drive object. The new units are not displayed

until after the download ("Load project to target system") and subsequent upload ("Load

project to PG") have been completed.

Commissioning parameter filter

IEC/NEMA mot stds

Selection of units system, motor equivalent circuit diagram data

Selection of units system

Selection of technological unit

Reference variable of technological unit

Reference frequency/speed

Reference voltage

Reference current

Reference torque

Reference power

Reference angle

Reference acceleration

Converter cabinet units

Operating Instructions, 03/2012, A5E03263466A