6.4.3
"NAMUR" default setting
Prerequisites
The NAMUR terminal block (option B00) is installed in the cabinet unit.
The "NAMUR" default setting was chosen during commissioning:
• STARTER:
• AOP30:
Command sources
Figure 6-13
Priority
The priority of the command sources is shown in the diagram "Command sources -
AOP30←→NAMUR terminal block".
Note
The EMERGENCY STOP and motor protection signals are always active (regardless of the
command source).
For LOCAL master control, all of the supplementary setpoints are deactivated.
Converter cabinet units
Operating Instructions, 03/2012, A5E03263466A
"NAMUR"
"7: NAMUR"
Command sources - AOP30←→NAMUR terminal block
Operation
6.4 Command sources
279