Inserting A Calibration Signal; Recording Layouts - Philips V24CT User's Reference Manual

Additional Information
Inserting a
You can insert a calibration signal into the waveform display on the
Calibration
monitor and into any actively running recording. Calibration signals are
Signal
automatically generated for calibrated waves. The signals can then be
used to determine the amplification of the waveform.
To insert the signal, press
press the
recording is being run, the signal appears on the display and is inserted
in the recording. Refer to Chapter 3, "Setting up your Monitor" for
further details.
Recording
Layout Choices on Recorder M1116A/B
Layouts
Layout
#1
#2
#3
#4
1
Alarm recordings always use layout #1, even if the delayed recordings
are configured with layout #2, 3, or 4.
6-44 Recording Functions
Cal Signals
Sector 1
1
20 mm
Wave 1
40 mm
Wave 1,2
20 mm
Wave 1
40 mm
Waves 1-3
, then
Trends/Calcs
softkey at the bottom of the screen, when a
Sector 2
20 mm
Wave 2
20 mm
Wave 2,3;
Mark Event
. If you