Symbols To Indicate Key Functions - Philips V24CT User's Reference Manual

special Service Mode, either by your biomedical engineering department
or the Philips service engineer. You can find a description of this behavior
(called "Parameter Settings Transfer") in Chapter 3.
Symbols to
As detailed in the table below, some modules used with the M1046A CMS,
Indicate Key
and M1205A V24/26 patient monitors now use symbols, instead of words,
Functions
to indicate the function of some keys. If the monitor's Reference Manual
tells you, for example, to select the START key, you should press the key
marked with the corresponding "start" symbol.
The design change also means that you will now find the module's
product number (for example M1032A) on the rear of the module's
housing, not on the front. Although the new modules do not show the
letter "T" on the housing, all modules retain their capability to transfer
parameter settings from one monitor to another.
Symbol Name
ZERO
Press
Out
Monitor
Module
START
Cal
Function
zero a pressure transducer
pressure outlet connector
initiates transfer from
module to monitor
initiates transfer from
monitor to module
start measurement
calibrate
Which Modules?
Pressure (M1006B), including
option C01
Pressure (M1006B) option C01
Data Transfer Module (M1235A)
CCO/C.O. (M1012A)
CCO/C.O. including option C10
SvO (M1021A), tcpO
2
(M1018A)
Mainstream CO
The CMS and V24 and V26 Patient Monitors 1-17
Parameter Modules
/tcpCO
2 2
(M1016A)
2