Hardkey Functions - Philips V24CT User's Reference Manual

Introduction
Hardkey
Silence/Reset
Functions
or, if alarms are latching, to reset them.
Suspend
is indicated by the Alarm Suspend Lamp.
Main Screen
or to access a 2nd or 3rd display. You can also freeze any wave
movement on the screen (INOPs, alarms and numerics are not affected).
recorder or a bedside recorder.
longer on the monitor screen.
Alarms
review alarm limits, enter Monitor Standby, or set the alarm volume.
Other Patients
your group.
Monitor Setup
characteristics.
Procedures
such as Cardiac Output, Wedge Pressure (CMS only), ST analysis, Drug
Calculations, admit and discharge patients, or end a particular patient
case and transfer patient data.
Trends/Calcs
trends, make and review calculations, print reports and mark events to
view in graphs.
Module Setup
settings, switch parameters on or off, or set up parameters.
1-12 The CMS and V24 and V26 Patient Monitors
- press to silence an alarm or alarms that are sounding
- press to suspend or switch on all alarms. The current state
- press to return to the main monitoring screen.
Change Screen - (CMS only) press to change between screen layouts
- press to record pre-selected waves onto a system
Realtime Record
- press to record pre-selected waveforms that are no
Delayed Record
- press to enable you to suspend or switch on alarms, set and
- press to enable you to view data from other beds in
- press to enable you to pre-select certain system
- press to enable you to set up and perform procedures
- press to enable you to view vital signs and graphical
- press to enable you to change or adjust parameter
Keys
Arrow