Panasonic KX-NS1000 Feature Manual page 212

10.1.17 IP-PT (IP Proprietary Telephone)
[Connection Example]
PBX
Private IP
V-IPEXT
Network
Primary
Ethernet Port
Main Office
Conditions
•
IP-PT registration is required through system programming before an IP-PT can be used with the PBX. An
IP-PT cannot be used unless an extension number is assigned. However, depending on system
programming, registration may occur completely automatically, or may require only inputting the desired
extension number. For details on how to register IP-PTs, see the Installation Manual.
•
The KX-NT265 does not have a secondary Ethernet port.
•
The following optional devices are available for the KX-NT300 series (except KX-NT321) IP-PT:
–
KX-NT307(PSLP1528) Bluetooth
–
KX-NT303 Add-on 12 Key Module (not available for KX-NT366)
–
KX-NT305 Add-on 60 Key Module (not available for KX-NT366)
•
The following optional devices are available for the KX-NT553/KX-NT556 IP-PT:
–
KX-NT505 Add-on 48 Key Module (maximum four units connectable).
•
DSP Resource Usage
Making a call from an IP-PT requires a certain number of DSP resources, depending on the codec used.
If all DSP resources are in use, this operation cannot be performed. To ensure a minimum level of
performance, DSP resources can be reserved for VoIP communication. (® 5.1.18 DSP Resource
Usage)
However, DSP resources are not required for P2P calls. (® 15.1.5 Peer-to-Peer (P2P) Connection)
•
KX-NT307(PSLP1528) Bluetooth Module
A Bluetooth wireless headset can be registered to a KX-NT300 series (except KX-NT321) IP-PT containing
the KX-NT307(PSLP1528) Bluetooth Module through personal programming. When Headset Mode is off,
the Bluetooth headset can be used to answer calls or redial. In this case, Headset Mode will turn on
automatically, and will turn off after you hang up.
This Bluetooth Module is also compatible with KX-DT343/KX-DT346 DPTs.
•
Calls made using a Bluetooth wireless headset will not be disconnected immediately when the user
wanders out of range. However, if the Bluetooth wireless headset user remains out of range for a specified
time period, the call will be disconnected.
•
The following features, available when a legacy gateway is connected (® 18.1.11 Stacking Connection),
cannot be used with an IP-PT:
–
XDP
–
Digital XDP
–
OHCA
•
Automatic Rerouting to Secondary PBX
A KX-NT300 series or KX-NT500 series IP-PT can automatically connect to a secondary PBX, when the
primary PBX becomes disconnected. When the primary PBX is connected again, the IP-PT reconnects to
it. (® 2.1.7 Automatic Rerouting to Secondary PBX)
212 Feature Manual
IP-PT
IP-PT PC
Secondary
Ethernet Port
Module
®
IP-PT
Branch Office
Document Version 2016-03