Panasonic KX-NS1000 Feature Manual page 23

[Carrier Selection Procedure Flowchart]
The numbers in parentheses indicate the corresponding items found under [Programming Procedures] on the
following pages.
An extension user accesses a CO
line and dials a telephone number.
Is the ARS mode (1) enabled?
Yes
Is the dialed number found in the
Leading Number Exception Table (2)?
No
Is the dialed number found in
the Leading Number Table (3)?
Yes
Checks the Routing Plan (4) to
determine which carrier to use.
Is the carrier found in the
appropriate time block (4)?
Yes
Is there an available
trunk group (5)?
Yes
Modifies the dialed number by
removing the digits and following
the modify commands (5).
Sends the modified number
to the CO line.
[Programming Procedures]
1.
ARS Mode
ARS is turned on by selecting under which circumstances it operates – either when an extension user
makes a call using the Idle Line Access method, or when any CO Line Access method is used (® 4.1.16 CO
Line Access). ARS can also be turned off for the entire system.
® 16.1 PBX Configuration—[8-1] ARS—System Setting—
2.
Leading Number Exception Table
Once ARS is activated, store the telephone numbers that will bypass ARS in the Leading Number Exception
Table.
Note that the first few digits (leading number) of a telephone number, such as an area code or local
exchange, can also be stored, so that all calls to those areas or exchanges are exempted from ARS. Also
note that the CO Line Access number is always ignored by ARS and does not need to be programmed
here.
Document Version 2016-03
No (Normal CO Line Access)
Sends the telephone
number as dialed.
Yes
No
No
No
No
Because all CO
lines are busy?
Is normal
Yes
CO Line Access
allowed?
No
Sends a
Sends a
reorder tone.
busy tone.
ARS Mode
2.1.3 ARS (Automatic Route Selection)
Yes
(default)
Sends the telephone
number by the Idle
Line Access.
Feature Manual 23