Testing The Nec Sl1100 Network Connection; Figure 4-3 Testing The Network Connection - NEC SL1100 Networking Manual

Issue 6.0
T
S 4
ESTING THE
ECTION
To test the NEC SL1100 network connection, it is possible to use the ICMP (Internet
Control Message Protocol) Ping command. This basically sends a small amount of
data from one device to another and then waits for a reply. This test confirms that the
IP addressing and physical connection are good. To perform this test, from a
Windows PC:
1.
2.
3.
4.
5.

Figure 4-3 Testing the Network Connection

replied to the Ping request – this indicates that the NEC SL1100 system is correctly
connected to the network.
4 - 6
NEC SL1100 N
Click Start.
Click Run... .
In the Open dialogue box, enter command.
Click OK. A Command prompt window opens.
Type ping 192.168.1.200.
Figure 4-3 Testing the Network Connection
C
ETWORK ONNECTION
shows that the NEC SL1100 system has
NEC SL1100
General IP Configuration