NEC SL1100 Networking Manual page 264

Issue 6.0
Program
Number
14-06-01 Trunk Group Routing
With SL Net, four new trunk group routing options
have been added and they are 101 ~ 104. These
options allow the caller to access and make calls
using one of the Remote Systems Trunks.
101 will access trunks from Remote system 1 that
is programmed in 10-27-01.
102 will access trunks from Remote system 2 that
is programmed in 10-27-01.
103 will access trunks from Remote system 3 that
is programmed in 10-27-01.
104 will access trunks from Remote system 4 that
is programmed in 10-27-01.
21-16-01 Trunk Group Routing for Networks
If a call comes in from across the network, this
program determines the route table (PRG 14-06-
01) that will be accessed in the local system.
15-07-01 Programmable Function Keys
This program is used on a per-station basis to
assign different function keys to the multiline
terminals.
Function key (*06) is used to assign a key on a
phone that will allow a user to access trunks out of
a remote system just by pressing the key.
When this key is assigned, an additional data of
1~4 is required. The additional data specifies
which Remote system you will access trunks
from.
When this key is used to access trunks out of a
Remote System, it will look at PRG 21-16-01 of
the system where the CO Line resides.
13 - 22
Program Name/Description Assigned Data
0 = No Setting
(Calls will not route)
001 – 025 = Trunk Group 1~25
101 ~ 104 = Remote systems 1~4
1001~1025 = Route Table 1~25
(default =1)
0 = No routing
(Calls will not route)
1 ~ 25 = Route table 1 ~ 25
(default =1)
*06 = Trunk Access via Networking
Secondary Settings:
1 = Remote System 1 from PRG 10-27
2 = Remote System 2 from PRG 10-27
3 = Remote System 3 from PRG 10-27
4 = Remote System 4 from PRG 10-27
(Refer to the SL1100 programming manual for
the default values and for all other available
options in this program.)
NEC SL1100
(PRG 14-06-01)
SL Net