NEC SL1100 Networking Manual page 196

Issue 6.0
9 - 62
5. The SIP MLT Station requires assignments to be made in the
phone itself. Enter the Program Mode in the station using the
following steps.
 The station does not require an Ethernet connection to enter the
program mode. Only power is required. Power can be provided
by an AC adapter plugged into the phone or by POE provided by
a data switch. If the data switch is providing POE it must be using
the 802.3AF standard.
For Basic bench testing only the following assignments are
required:
At this point you are prompted with a User Name and

Password. These are the defaults:
User Name: ADMIN
Password: 6633222
The user name should already be entered in the terminal.

Press Set soft key to step down to the password field.

After you enter the password, press OK soft key.

Network Settings
DHCP Mode – DHCP Disable. Click OK.

IP Address – Enter the IP Address for the station, and click

OK.
Default Gateway – Enter the Default Gateway Address, and

click OK. If you are testing without a router/gateway, this
must be left at the default 0.0.0.0
Subnet Mask - Enter the Subnet Mask for the station, and

click OK.
SIP Settings
SIP User – Intercom Number

Enter the extension number for the IP station, and click OK.
Server Address & URI – 1st Server Address

Enter the IP address assigned in command 10-12-09, and
click OK.
NEC SL1100
IP Multiline Station (SIP)