NEC SL1100 Networking Manual page 126

Issue 6.0


Default Settings

System Availability
Required component(s):


8 - 2
While the system accesses the DHCP Server, to receive IP Addressing
information, the CPU RUN LED flashes as follows. If the system fails to receive
an IP Address from the DHCP Server, the system uses the IP Address assigned
in PRG 10-12.
After the IP Address and Subnet Mask are set, if different IP Addresses or
Subnet Mask is delivered during normal operation mode, both LED2 (Red lit)
and RUN LED (flash as above) indicate system requires reset.
Enabled
IP4[ ]-1228M-B KSU
IP4WW-VOIPDB-C1
NEC SL1100
DHCP Client