NEC SL1100
5.7
5.8
5.9
Networking Manual
Network Address Port Translation (NAPT)
NEC SL1100 SIP trunk can pass through a NAPT router. The related system
data is
Program 10-12-06 : CPU-B1 Network Setup
Program 10-12-07 : CPU-B1 Network Setup
set with a dynamic router IP address).
Incorrect settings with these two programs can cause one-way audio
problems.
The WAN global IP is set in the system data by the user or automatically using
the NAT traversal feature (UPnP). The related system data is
–
Setup
UPnP Mode
(polling timer).
Quality of Service (QoS)
NEC SL1100 SIP trunks support Type of Service (ToS) (
, protocol type = 6 (SIP Trunk).
Setup
Registration
5.9.1
Registration Process
When the NEC SL1100 system registers its own IDs with an external
SIP server, the following system data are sent:
Register ID #
User ID
Register ID 0
10-36-02
Register ID 1
10-36-02
:
10-36-02
:
Register ID 31
10-36-02
The NEC SL1100 sends the REGISTER Message when the system
starts up, register timer expires, CPU LAN links and recover timer
expires.
5.9.2
Registration Recover Process
The NEC SL1100 has a registration recovery process for registration
failure. When a registration fails, the NEC SL1100 sets an internal
recover timer. When the timer expires, the NEC SL1100 sends a
REGISTER message per register ID again.
(On/Off) and
10-37-02 : UPnP Setup
Authentication
ID
10-36-03
10-36-03
10-36-03
10-36-03
–
NAPT Router (On/Off)
–
NAPT Router IP Address
10-37-01 : UPnP
–
UPnP Interval
Program 84-10 : ToS
Authentication
Password
10-36-04
10-36-04
10-36-04
10-36-04
Issue 6.0
and
(do not
7 - 9