NEC SL1100 Networking Manual page 268

Issue 6.0
Call Routing – Inbound (DID)
22-02-01
22-11-01
22-11-02
22-11-04
13 - 26
Program
Program Name/Description
Number
*
Incoming Call Trunk Setup
ISDN PRI or SIP trunks at any
location can send a DID
directly to any extension
number in the SL Net network.
Trunks must be set to type (3)
DID to follow the digit
conversion tables.
*
Received Number
Enter the digits received from
the Telco that are going to be
translated.
The amount of digits entered
should be equal to the setting
assigned in program 22-09-01.
*
Target Number
Enter the destination number
where the DID is sent.
The destination can be any
valid extension number in the
SL Net network.
Transfer Operation Mode
The transfer operation mode
allows DID calls to have more
routing options than just the
target number. If the transfer
operation mode is set to "No
Transfer", calls will only be
delivered to the Target Number
specified in program 22-11-02.
If set to one of the three other
modes, it will follow that mode
through all assigned transfer
destinations.
Assigned Data
0 = Normal
1 = VRS
2 = DISA
3 = DID
4 = DIL
5 = Tie Line
6 = Delay VRS
7 = ANI/DNIS
8 = DID (DDI) Mode Switching
(default =0)
Maximum of 8 digits
(0~9, *, #,)
(default =Not Assigned)
Maximum of 8 digits
(0~9, *, #,@)
(default =Not Assigned)
0 = No Transfer
1 = Busy
2 = No Answer
3 = Busy/No Answer
(default =0)
NEC SL1100
SL Net