I Nstallation - NEC Univerge SV8100 System Hardware Manual

UNIVERGE SV8100
4.2.2
4.2.3
System Hardware Manual
CHUYÊN CUNG CẤP TỔNG ĐÀI NEC
Installation
The PZ-8DLCB is installed on the CD-8DLCA. To install:
1. Connect the PZ-8DLCB to the CN2 connector on the CD-8DLCA blade.
Refer to Figure 4-12 CD-8DLCA Blade on page 4-34
the connectors on the blade.
2. Install the CD-8DLCA into a slot.
3. Each CNx01 connector (CN101, CN201, CN301, CN401) is used to
connect up to four digital extensions.
PZ-8DLCB Daughter Board Cable Connection
The PZ-8DLCB blade has connections for CN301 and CN401. Refer to
Figure 4-13 CD-16DLCA Blade
The following tables show the cable connections of the two RJ-61
connectors on the PZ-8DLCB.
Table 4-22 PZ-8DLCB CN301/CN401 Connection
PZ-8DLCB – CN301 (ports 9~12), CN401 (ports 13~16)
for connector locations.
RJ-61 Cable Connector
Pin No.
1
2
3
4
5
6
7
8
http//vietpro.com.vn
for the location of
Connection
T4 (Tip for port 4)
T3 (Tip for port 3)
T2 (Tip for port 2)
R1 (Ring for port 1)
T1 (Tip for port 1)
R2 (Ring for port 2)
R3 (Ring for port 3)
R4 (Ring for port 4)
4-41