NEC Univerge SV8100 System Hardware Manual page 315

5-90
CHUYÊN CUNG CẤP TỔNG ĐÀI NEC
6.4.2 Wall Mounting the Bluetooth Cradle
To prevent possible damage to the BCH-L (BK) UNIT
due to falling, NEC recommends installing the unit in a
firm position so it will not fall due to its own weight.
Clearances required for installing the Bluetooth cradle are shown
below. Avoid mounting the cradle on a plaster-board wall, but before
mounting the cradle on a wall, check that the wall can support the
weight of the telephone and withstand the load from pulling the
telephone during operation.
Figure 5-113 Wall Mount Spacing Guide BCH-L (BK) UNIT
1. Attach two wood screws to the wall.
Keep a clearance of about 0.08" (2mm) between each wood
screw and the wall (refer to
page 5-91).
Installing DT300/DT700 Series (DTL/ITL) Digital and IP Multiline Terminals
UNIVERGE SV8100
Figure 5-114 Installing Wood Screws on
http//vietpro.com.vn