NEC Univerge SV8100 System Hardware Manual page 368

UNIVERGE SV8100
System Hardware Manual
CHUYÊN CUNG CẤP TỔNG ĐÀI NEC
3. Lower the tilt leg to the first position (refer to
Leg from Leg Support).
Figure 6-30 Separate Tilt Leg from Leg Support
4. Push the two stopper tabs through the slots to separate the tilt leg from
the leg support.
5. Lay the tilt leg and the leg support flat to expose APR-L UNIT
compartment.
6. Carefully pry loose the knockout covering the bottom option interface
(refer to Figure 6-31 Bottom Option Interface
Figure 6-31 Bottom Option Interface Knockout
7. Using the exposed Bottom Option Interface as a guide, install the
APR-L UNIT in the bottom of the DTL multiline terminal. Push down
until left and right tabs are seated (Refer to
UNIT on page 6-42).
http//vietpro.com.vn
Figure 6-30 Separate Tilt
Knockout).
Figure 6-32 Install APR-L
6-41