SmartLogger2000-(10-C, 11-C)
User Manual
Figure 7-59 Setting IEC103 parameters
7.9.2.7 Setting IEC104 Parameters
If the SmartLogger connects to a third-party NMS over the IEC104 protocol, IEC104
parameters must be correctly set to enable the third-party NMS to monitor the running status
of devices connected to the SmartLogger.
Because of permission restriction, log in as Advanced User. Choose Settings > IEC104 to
access the target page.
Issue Draft A (2017-02-15)
IEC103 is a general standard protocol without a security authentication mechanism. To reduce
network security risks, the function of connecting to a third-party NMS using IEC103 is disabled by
default. To use this function, set Link setting to Enable.
Third-party devices and Huawei devices must be connected to different ports of the SmartLogger.
Otherwise, the communication will be abnormal.
The value of IEC103 IP must be consistent with the NetEco IP address.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
7 WebUI
142